Manuals, Data Sheets, and Press Releases can be found in the MPL Documentation area of this homepage.
|Question #247:||My MPL SBC does not [boot|start] up. What can I do?|
|Answer:|| First of all, what precisely is meant by "does not [boot|start] up"?
Is the system not powering up at all or is there some reaction / output from the BIOS/bootloader, but no operating system is loaded or started?
If it is the former, please do the following:
Please note that the above is just a rough list of things to check and try. Please use the corresponding manual for detailed information and precise instructions for a particular MPL product.
|Question #248:||The RESET LED is blinking. What's wrong?|
|Answer:||This means that the internal power supply of the SBC has detected an overload or even short-circuit condition on one of its power rails.
Please follow the steps below:
|Question #406:||The BIOS update process for your SBC products seems to be floppy based. But I don't have access to a floppy and/or a floppy drive. Is there an alternative way to update the BIOS?|
|Answer:||For MPL systems with USB boot capability, please follow the steps below:
|Question #272:||What is delivered with the PIP?|
|Answer:||There are several differently equipped base versions available. Additionally, you can choose the amount of DRAM, the type of mass storage (Hard / Flash disk) etc. according to your requirements. Please see the "PIP Options" entry in our Homepage for further information or contact one of our distributors for assitance.|